Verify your YouTube account To verify your channel, you’ll be asked to enter a phone number. We’ll send a verification code by text or voice call to that phone number. Once you've verified your account, you can: Upload videos longer than 15 minutes. Add custom thumbnails. Live stream. Appeal Content ID claims.
What s the rule of thumb before cutting coils? Discussion in ' The Hokey Ass Message Board ' started by Garage Concepts, .
What s the rule of thumb before cutting coils? | The H.A.M.B.
Roll oversteer feels twitchy. There are lots of "rules of thumb" about what should be parallel or pointing up or down. Mostly it's all bunk. Just do the calculations and design a geometry for the handling characteristics you want. Some adjustability is always a good thing as well.
a good rule of thumb is, whatever you can add going from 1.5 to 1.65 rockers, i.e. around 10% more lift, you can generally grind into the cam itself for hydro flat tappet. then if you run the same 1.65 rockers, you can add that much more again with rocker ratio. so...in case of a Pontiac V8, a .470" lift cam can become a .510" lift cam, then ...
Rickybop ALLIANCE MEMBER from the thumb of Michigan Huh... it's a 2-door. What is it?
from the thumb of Michigan Welcome to the HAMB. Best hot rod site in the galaxy. Gene said it well. Just hang around for a little while, get your 10 posts in, and get the hang of what all the ****ons do. Read some of the discussions. Good info, humor, camaraderie even. Plenty of old farts here. You'll fit right in. Rickybop, ...